LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body Diagnostic Procedures >> Diagnostic Information And Procedures >> Instrument Cluster >> Symptom: *"NO FUSE" IN VF DISPLAY >> Diagnostic Procedure

Diagnostic Procedure

DIAGNOSTIC INFORMATION AND PROCEDURES CHART (NO BUS IN VF DISPLAY)

TEST ACTION APPLICABILITY
1 Turn the ignition off.
Inspect the #24 fuse in the Power Distribution Center.
If the fuse is open, replace with proper rated fuse.
Turn the ignition on for one minute.
Turn the ignition off.
Inspect the #24 fuse in the Power Distribution Center.
Is the fuse open?
Yes --> Repair the Fused B(+) circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Go To 2		 All
2 Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Check connectors - Clean/repair as necessary.
Measure the voltage between the Fused B(+) circuit and ground.
Is the voltage above 10.5 volts?
Yes --> Replace and configure the Instrument Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST - VER 1 .		 All
scientia non olet · About LEMON Manuals