Diagnostic Procedure
DIAGNOSTIC INFORMATION AND PROCEDURES CHART (CHIME SOUNDS WITH DRIVER'S DOOR OPEN, KEY REMOVED)
| TEST | ACTION | APPLICABILITY |
|---|---|---|
| 1 | Disconnect the Ignition Switch connector. Did the chime turn off? Yes --> Check the Ignition Lock Cylinder for damage. If OK replace the Ignition Switch. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 2 |
All |
| 2 | Turn ignition off. Disconnect the Ignition Switch connector. Remove the Instrument Cluster from the I/P. Measure the resistance of the Key-in Ignition Switch Sense circuit to ground at the Instrument Cluster C2 connector. Is the resistance below 100.0 ohms? Yes --> Repair the Key-In Ignition Switch Sense wire for a short to ground.. Perform BODY VERIFICATION TEST - VER 1 . No --> Go To 3 |
All |
| 3 | If there are no possible causes remaining, view repair. Repair Replace the Instrument Cluster. Perform BODY VERIFICATION TEST - VER 1 . |
All |