LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Powertrain Diagnostic Procedures - DRIVEABILITY - NGC Symptoms & Diagnostic Tests (DTCS P0016 To P0563)) >> DRIVEABILITY - NGC - Diagnostic Tests >> P0501-Vehicle Speed Signal No. 1 Performance; P0503-Vehicle Speed Signal No. 1 Erratic; (Gas - NGC) >> When Monitored and Set Condition: >> P0501-Vehicle Speed Signal No. 1 Performance

P0501-Vehicle Speed Signal No. 1 Performance

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

When Monitored: With the engine running, transmission not in park or neutral, brakes not applied, and engine rpm greater than 1500.

Set Condition: This code will set if no vehicle speed signal is received from the ABS/RWAL Module for more than 11 seconds for 2 consecutive trips. Two Trip Fault. Three good trips to turn off the MIL.