LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Powertrain Diagnostic Procedures - DRIVEABILITY - NGC Symptoms & Diagnostic Tests (DTCS P0016 To P0563)) >> DRIVEABILITY - NGC - Diagnostic Tests >> P0340-Camshaft Position Sensor Circuit (Gas - NGC) >> When Monitored and Set Condition:

When Monitored and Set Condition:

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

When Monitored: Engine cranking/running. Battery voltage greater than 10.4 volts.

Set Condition: At least 5 seconds or 2.5 engine revolutions have elapsed with crankshaft position sensor signals present but no camshaft position sensor signal. One Trip Fault. Three good trips to turn off the MIL.