LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler X, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 628 (Powertrain Diagnostic Procedures - DRIVEABILITY - NGC Symptoms & Diagnostic Tests (DTCS P0016 To P0563)) >> DRIVEABILITY - NGC - Diagnostic Tests >> P0325-Knock Sensor No. 1 Circuit; P0330-Knock Sensor No. 2 Circuit (Gas - NGC) >> When Monitored and Set Condition:

When Monitored and Set Condition:

WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

When Monitored: With the engine running >1312 RPM, coolant temp >65.25°C (149.45°F), MAF >250mg/tdc and no ECT, MAF or CAM Sensor DTCs.

Set Condition: The Knock Sensor error program internal to the PCM is on, the Knock Sensor voltage is <.49 volt, and the value of the Knock Sensor changes less than.06 volt for >11 seconds. One Trip Fault. Three good trips to turn off the MIL.