LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 607 (Power Door Locks (Service Information)) >> Remote Keyless Entry Transmitter >> Standard Procedure >> Remote Keyless Entry Customer Preferences >> Unlock Sequence

Unlock Sequence

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The unlock sequence can be toggled using a scan tool or by using the following procedure.

  1. Place the key in the ignition.
  2. Within 10 seconds, cycle the key from the OFF position to the ON position four times, ending in the ON position (Do not start the engine).
  3. Within 30 seconds, press the driver's door lock switch in the UNLOCK direction. A single chime will be heard to indicate the feature has been disabled.

This will toggle between Driver door first and Unlock all doors function.

To ENABLE this feature, repeat the above procedure.

scientia non olet · About LEMON Manuals