LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (Chime & Buzzer (Service Information)) >> Park Assist Display >> Removal

Park Assist Display: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Park Assist Display
GC0015713Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Lower the headliner (3) in the rear of the vehicle in the liftgate opening. Follow the headliner removal procedure for the rear of the headliner (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) .
  3. Bend the retaining tabs (2) upwards to allow the park assist display (1) to drop out of the headliner (3) opening.
  4. Disconnect the display electrical connector (4) and remove display (1) from vehicle.