LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (Chime & Buzzer (Service Information)) >> Park Assist Display >> Installation

Park Assist Display: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Park Assist Display
GC0015713Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the Park Assist Display (1) in headliner (3) opening and connect the display electrical connector (4).
  2. Bend the retaining tabs (2) down behind the headliner (3).
  3. Raise the headliner in the rear of the vehicle in the liftgate opening (Refer to BODY/INTERIOR/HEADLINER - INSTALLATION) .
  4. Connect the battery negative cable.
scientia non olet · About LEMON Manuals