LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (Battery System - Service Information) >> Battery Tray >> Removal - Gas Engine

Removal - Gas Engine

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Battery Wire Harness
GC0029013Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the battery from the battery tray (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - REMOVAL) .
  2. Remove the battery wire harness three pin connector (11) from the battery tray (12).
    Fig 2: Remove/Install Battery Tray
    GC0029019Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the two screws (3) that secures the battery tray (4) to the inner fender and the bracket on the radiator support.
  4. Remove the one screw (2) that secures the outboard side of the battery tray (4) to the left inner fender.
  5. Remove the one nut (1) that secures the rear of the battery tray to the stud (5) on the front frame rail.
  6. Remove the battery tray from the left front corner of the engine compartment.
scientia non olet · About LEMON Manuals