Washer Reservoir: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Reservoir Neck Mounting

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate the negative battery cable.
Open the washer reservoir filler cap and remove the filler cap hinge from the hook on the filler neck.
Remove the retainer (1) that secures the washer reservoir filler neck to the upper radiator support.

Fig 2: Washer Reservoir Elec Conn
Courtesy of DAIMLERCHRYSLER CORP.
Raise and support the vehicle.
Remove the liner from the left front fender wheel house to gain access to the washer reservoir (1).
Disconnect the wire harness connectors (2) from the washer fluid level switch (3) and the windshield washer pump (4).
NOTE: To aid in reinstallation, note the installed position of the washer hoses prior to disconnecting them from the windshield washer pump.
Disconnect the two washer hoses from the windshield washer pump and allow the washer fluid to drain into a clean container for reuse.

Fig 3: Washer Reservoir R/I
Courtesy of DAIMLERCHRYSLER CORP.
Remove the two screws (2) that secure the washer reservoir (1) to the left front frame rail.
CAUTION: Care must be taken not to damage the reservoir during removal.
Remove the washer reservoir from underneath the vehicle. Rotate the reservoir as necessary to gain clearance.