Sensor-Washer Fluid Level: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Fluid Level Switch

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle.
Remove the liner from the left front fender wheel house.
Disconnect the wire harness connector (1) from the top of the washer fluid level switch (2).
CAUTION: Care must be taken not to damage the reservoir during washer fluid level switch removal.
Using a trim stick C-4755 or equivalent, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet located on the reservoir (3).
Carefully rotate the washer fluid level switch until it can be removed from the reservoir sump and remove and discard the rubber grommet.