Right Multi-Function Switch: Installation
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the right multi-function switch (3) onto the multi-function switch mounting housing (4) and connect it to the steering control module (SCM).
- Engage the two retaining tabs (2) that secure the right multi-function switch to the multi-function switch mounting housing.
- Install the two screws (1) that secure the right multi-function switch to the multi-function switch mounting housing. Tighten the screws to 2.5 N.m (22 in. lbs.).
- Position the lower steering column shroud (2) to the underside of the steering column.
- Install the three screws (1) that secure the lower steering column shroud to the multi-function switch mounting housing. Tighten the screws to 2 N.m (17 in. lbs.).
- Position the upper column shroud (3) over the steering column with the hazard warning switch button inserted through the hole in the upper shroud.
- Align the snap features on the upper and lower shrouds and apply hand pressure to snap them together.
- Reconnect the negative battery cable.