LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 593 (Wiper System & Washer System (Service Information)) >> Relay-Wiper High/Low >> Installation

Relay-Wiper High/Low: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wiper High/Low Relay-R and I
GC0029514Courtesy of DAIMLERCHRYSLER CORP.
NOTE: Refer to the fuse and relay layout map on the inside of the integrated power module (IPM) cover for wiper high/low relay location.
  1. Position the wiper high/low relay (2) into the proper receptacle of the IPM (1) located in the engine compartment.
  2. Align the wiper high/low relay terminals with the terminal cavities in the IPM receptacle and push down firmly on the relay until the terminals are fully seated.
  3. Close the cover of the IPM.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals