Rain Sensor Module: Removal
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Disconnect the wire harness connector from the rain sensor module.
- Using a small screwdriver or equivalent, push in on the tabs from the connector side of the sensor housing until the two sliders (1) protrude from the opposing side of the housing.
- Gently pull each slider out from the sensor housing until the cam locks release the sensor from the mounting bracket located on the windshield glass.