Rain Sensor Module: Installation
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the two sliders (1) are positioned in the downward position, sticking out of the side opposite of the rain sensor module connector.
- Position the rain sensor module over the mounting bracket located on the windshield glass and gently push down to seat it on the bracket.
- Push the two sliders inward until they are flush with the side of the sensor housing and the cam locks are fully engaged.
- Connect the wire harness connector to the rain sensor module.
- Reconnect the negative battery cable.