Section 593 (Wiper System & Washer System (Service Information)): Pump-Washer-Windshield: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Pump/Motor

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle.
Remove the liner from the left front fender wheel house.
Disconnect the wire harness connector (1) from the top of the windshield washer pump (2).
NOTE: To aid in reinstallation, note the installed position of the washer hoses prior to disconnecting them from the windshield washer pump.
Disconnect the washer hoses (3) from the barbed outlet nipples of the windshield washer pump and allow the washer fluid to drain into a clean container for reuse.
CAUTION: Care must be taken not to damage the reservoir during windshield washer pump removal.
Using a trim stick C-4755 or equivalent, gently pry the barbed inlet nipple of the windshield washer pump out of the rubber grommet located on the reservoir (4) and remove and discard the rubber grommet.