LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Audio System & Video System (Service Information)) >> Antenna Cable - Instrument Panel >> Removal >> Domestic

Antenna Cable - Instrument Panel: Removal: Domestic

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Radio, Locking Antenna Connector & Instrument Panel Cable
GC0028955Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove radio (Refer to ELECTRICAL/AUDIO/RADIO - REMOVAL) .
    CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
  3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).
    Fig 2: Identifying Instrument Panel Cable & Antenna Cable
    GC0028956Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the glove box.
  5. Remove instrument panel side panel.
  6. Disconnect instrument panel cable (1) from antenna body and cable (2).
    Fig 3: Removing/Installing Antenna Cable
    GC0028954Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove the antenna retaining straps and remove antenna cable (4).
scientia non olet · About LEMON Manuals