LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Audio System & Video System (Service Information)) >> Antenna Body & Cable >> Removal >> Export

Antenna Body & Cable: Removal: Export

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Antenna Body & Cable - Export
GC0028949Courtesy of DAIMLERCHRYSLER CORP.
WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, SIDE AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the assist handles on the right side of the headliner.
  3. Remove the right side visor.
  4. Remove the A-pillar trim.
  5. Disconnect antenna cable from instrument panel antenna cable.
    Fig 2: Disconnecting/Connecting Antenna Cable
    GC0028950Courtesy of DAIMLERCHRYSLER CORP.
  6. Lower headliner as necessary to access antenna cable.
  7. Disconnect antenna cable from antenna module.
  8. Remove antenna cable from roof panel by pulling on retaining clips.
scientia non olet · About LEMON Manuals