Tail Lamps: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bulb & Socket

Courtesy of DAIMLERCHRYSLER CORP.

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring. Do not touch the bulb glass with fingers or other oily surfaces. Reduced bulb life will result.

Position the bulb (1) in the socket (2) and push into place.

Fig 2: Identifying Retaining Tabs
Courtesy of DAIMLERCHRYSLER CORP.
Position the bulb socket in the tail lamp unit and push firmly into place until the retaining tabs (1) are fully engaged.

Fig 3: Removing/Installing Tail Lamp Unit
Courtesy of DAIMLERCHRYSLER CORP.
Install the tail lamp assembly (3) (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/TAIL LAMP - INSTALLATION) .