Tail Lamp Unit: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tail Lamp Unit Screws

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate the battery negative cable.
Open liftgate and remove the two screws (1) attaching the lamp to the body.

Fig 2: Removing/Installing Tail Lamp Unit
Courtesy of DAIMLERCHRYSLER CORP.
Pull tail lamp unit (3) rearward to disengage the lamp alignment pins from the body (1).

Fig 3: Disconnecting/Connecting Lamp Unit Wire Harness Connector
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect lamp unit wire harness connector.
Remove the lamp unit from vehicle.