Left Multi-Function Switch: Installation
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.
- Position the left multi-function switch (1) onto position on the Steering Control Module (SCM) (2).
- Engage the two retaining tabs, next to the screw mounts that secure the left multi-function switch and firmly snap into place.
- Install the two screws (3) that secure the left multi-function switch to the SCM. Tighten the screws to 2.5 N.m (22 in. lbs.).
- Position the lower steering column shroud (2) to the underside of the steering column.
- Install the three screws (1) that secure the lower steering column shroud to the multi-function switch mounting housing. Tighten the screws to 2 N.m (17 in. lbs.).
- Position the upper column shroud (3) over the steering column with the hazard warning switch button inserted through the hole in the upper shroud.
- Align the snap features on the upper and lower shrouds and apply hand pressure to snap them together.
- Reconnect the battery negative cable.