LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 591 (Lighting Systems - Exterior (Service Information)) >> Fog Lamp Unit >> Installation >> Installation

Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Fog Lamp Unit
GC0029230Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the fog lamp unit in the lower fascia. There are two alignment dowels (2) to assist in this step.
  2. Install the two screws (3) attaching fog lamp unit to fascia.
  3. Install the fog lamp (1) and turn it one quarter turn clockwise.
  4. Connect the fog lamp electrical connector (4).
  5. Align the fog lamp, if necessary (Refer to ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/FOG LAMP UNIT - ADJUSTMENTS) .
  6. Align the inner wheel well with the lower front fascia and install push pins.
  7. Connect the battery negative cable.