LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (Horn System (Service Information)) >> Horn >> Removal

Section 586 (Horn System (Service Information)): Horn: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removal And Installation Of Horn System
GC0029095Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Raise and support the vehicle.
  3. Remove the lower front half of the inner liner from the right front fender wheel house.
  4. Disconnect the electrical harness connectors.
  5. Remove the mounting fastener.
  6. Remove both horns and the mounting bracket as a unit.
scientia non olet · About LEMON Manuals