LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 569 (Nag1 Automatic Transmission - Shifter Diagnostics) >> DTC Troubleshooting >> P0931-BTSI Control Circuit High >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  ENGINE DTC'S PRESENT 

    With the scan tool, read Engine DTCs.

    Are there any Engine brake DTC's present? 

    Yes 

    1. Refer to DTCS P0016 TO P0118, DIAGNOSTIC CODE INDEX, PRE-DIAGNOSTIC TROUBLESHOOTING, INTERMITTENT CONDITION and perform the appropriate diagnostic procedure.
    2. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1 .

    No 

    1. Go To step  2).
  2. 2)  ABS MODULE DTC'S PRESENT 

    With the scan tool, read ABS Module DTCs.

    Are there any ABS DTC's present? 

    Yes 

    1. Refer to BRAKE CONTROLLER ELECTRICAL DIAGNOSTICS and perform the appropriate diagnostic procedure.
    2. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1 .

    No 

    1. Go To step  3).
  3. 3)  (B29) BRAKE SWITCH SIGNAL OPEN 
    Fig 1: Checking Brake Switch Signal For Open
    GC0012589Courtesy of DAIMLERCHRYSLER CORP.

    Turn the ignition off to the lock position.

    Disconnect the Shift Lever Assembly harness connector.

    Disconnect the Stop Lamp Switch harness connector.

    NOTE: Check connectors - Clean/repair as necessary.

    Measure the resistance of the (B29) Brake Switch Signal circuit between the Shift Lever Assembly harness connector and the Stop Lamp Switch.

    Is the resistance above 5.0 ohms? 

    Yes 

    1. Repair the (B29) Brake Switch Signal for an open.

    No 

    1. Go To step  4).
  4. 4)  (B29) BRAKE SWITCH SIGNAL SHORT TO VOLTAGE 
    Fig 2: Checking Brake Switch Signal For Short
    GC0012590Courtesy of DAIMLERCHRYSLER CORP.

    Turn the ignition off to the lock position.

    Disconnect the Shift Lever Assembly harness connector.

    NOTE: Check connectors - Clean/repair as necessary.

    Turn the ignition on.

    Measure the voltage of the (B29) Brake Switch Signal circuit.

    Is the voltage above 0.5 volts? 

    Yes 

    1. Repair the (B29) Brake Switch Signal for a short to voltage.

    No 

    1. Go To step  5).
  5. 5)  SHIFT LEVER ASSEMBLY 

    Using the schematics as a guide, inspect the wiring and connectors. Repair as necessary. Pay particular attention to all power and ground circuits.

    If there are no possible causes remaining, view repair. 

    Repair 

    1. Replace the Shift Lever Assembly per the Service Information.
    2. Perform NAG1 TRANSMISSION VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals