LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 568 (Air Bag Restraint Systems (Service Information)) >> Seat Belt Buckle >> Removal >> Rear

Seat Belt Buckle: Removal: Rear

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: To avoid personal injury or death, during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or inoperative buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or faulty seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar Parts Catalog.
Fig 1: Remove/Install Rear Seat Belt Buckle
GC0027751Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the rear seat cushion from the vehicle. (Refer to BODY/SEATS/REAR SEAT CUSHION - REMOVAL) .
  2. Remove the screw (1) that secures the rear seat back bracket (5) and the right outboard and center buckles (4) or the left buckle (3) and center seat belt (2) lower anchor to the rear floor panel.
  3. Remove the rear seat belt buckle from the rear floor panel.
scientia non olet · About LEMON Manuals