K3-Input Clutch: Disassembly
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - SNAP-RING | 6 - PISTON |
| 2 - MULTIPLE DISC PACK | 7 - SEALING RING |
| 3 - DISC SPRING | 8 - OUTER DISC CARRIER |
| 4 - SNAP-RING | 9 - MULTI-USE SPRING COMPRESSOR 8900 |
| 5 - SPRING PLATE |
- Remove snap-ring (1) from outer multiple-disc carrier. See Fig 1.
- Remove multiple-disc pack (2) and disk spring (3) from outer multiple-disc carrier. Note which clutch disc is removed just prior to the spring plate (3) for re-assembly. If the clutch discs are re-used, this disc must be returned to its original position on top of the spring plate.
- Place Multi-use Spring Compressor 8900 (9) on disc spring (5) and compress the spring until the snap-ring (4) is exposed. See Fig 1.
- Remove snap-ring (4).
- Remove spring plate (5) and piston (6) from outer multiple-disc carrier.