Evaporative Emissions: Canister-Vapor: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

To Install NVLD Pump to EVAP canister:

Fig 1: Identifying NVLD Pump O-Ring

Courtesy of DAIMLERCHRYSLER CORP.

Install new NVLD pump o-ring (2) to EVAP canister (1).

Fig 2: Identifying NVLD Pump
Courtesy of DAIMLERCHRYSLER CORP.
Position NVLD pump (4) into EVAP canister (1).
Rotate pump (4) until tab (3) aligns with notch in EVAP canister (1).
To Install EVAP canister:

Fig 3: Installation EVAP Canister
Courtesy of DAIMLERCHRYSLER CORP.
Position canister (5) into mounting bracket (4). Install and tighten two canister-to-mounting bracket nuts.
Position canister/pump assembly to body. Install and tighten three mounting bracket-to-body nuts.

Fig 4: Identifying NVLD / EVAP Canister Location
Courtesy of DAIMLERCHRYSLER CORP.
Carefully install vapor/vacuum lines (1) and (6) to NVLD pump and EVAP canister. The vapor/vacuum lines and hoses must be firmly connected. Check the vapor/vacuum lines at the NVLD pump, filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set.
Connect electrical connector (4) to pump.
Install plastic splash shield at rear of left-rear tire.
Install left-rear tire.