Cable-Park Lock: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Key/Switch Positions

Courtesy of DAIMLERCHRYSLER CORP.

1 - LOCK

2 - ACC

3 - ON

4 - START

Place ignition key in the ACC (2) position. See Fig 1

Fig 2: Park Lock Cable at Ignition Cylinder

Courtesy of DAIMLERCHRYSLER CORP.

1 - RETAINER

2 - CONNECTOR

3 - IGNITION CYLINDER

4 - PARK LOCK CABLE

Remove the lower instrument panel trim as necessary to access the park lock cable.

Disconnect park lock cable (4) from ignition cylinder (3). See Fig 2.

Fig 3: Gearshift and Park Lock Cable at Shifter Assembly

Courtesy of DAIMLERCHRYSLER CORP.

1 - SHIFTER ASSEMBLY

2 - ADJUSTMENT NUT

3 - SHIFT CABLE

4 - SHIFT CABLE ATTACHMENT

5 -PARK LOCK CABLE

Remove the floor console as necessary for access to the park lock cable. (Refer to BODY/INTERIOR/FLOOR CONSOLE - REMOVAL)
If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the shifter assembly and remove the shield.
Disconnect the park lock cable (5) from the shift mechanism. Release retention tab using suitable screwdriver. See Fig 3.