LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (HVAC Systems (Service Information)) >> Plumbing >> Line-A/C Discharge >> Installation >> 3.7L/4.7L Engines

3.7L/4.7L Engines

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Suction/Discharge Lines- R and I
GC0028353Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the A/C discharge line (4) into the engine compartment.
  2. Remove the tape or plugs from the discharge line fittings and the A/C compressor (2) and A/C condenser (3).
  3. Lubricate new dual plane seals with clean refrigerant oil and install them onto the A/C discharge line. Use only the specified seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  4. Install the A/C discharge line onto the A/C compressor.
  5. Install the nut (1) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 20 N.m (15 ft. lbs.).
  6. Install the A/C discharge line onto the A/C condenser.
  7. Install the nut (5) that secures the A/C discharge line to the A/C condenser. Tighten the nut to 20 N.m (15 ft. lbs.).
  8. Install the air cleaner housing, air intake tube and the resonator (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION) .
  9. Install the grille (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION) .
  10. Reconnect the negative battery cable.
  11. Evacuate the refrigerant system. (Refer to REFRIGERANT SYSTEM EVACUATE  ).
  12. Charge the refrigerant system. (Refer to REFRIGERANT SYSTEM CHARGE  ).
scientia non olet · About LEMON Manuals