LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (HVAC Systems (Service Information)) >> Distribution >> HVAC Housing >> Installation >> Air Inlet Housing

Air Inlet Housing

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
Fig 1: Air Inlet Housing R and I
GC0028336Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the air distribution housing (4) onto the top of the HVAC housing (5) by inserting the two tabs located at the front of the air inlet housing into the slots located on the top of the HVAC housing.
  2. Tip the air distribution housing downward until it is properly seated on the HVAC housing.
  3. Install the three screws (3) that secure the air distribution housing to the HVAC housing. Tighten the screws to 2.2 N.m (20 in. lbs.).
  4. Connect the HVAC wire harness (1) to the recirculation door actuator (2).
  5. Install the HVAC housing assembly (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HOUSING-HVAC - HVAC HOUSING ASSEMBLY - INSTALLATION) .
scientia non olet · About LEMON Manuals