LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (HVAC Systems (Service Information)) >> Controls >> Module-Power-Blower Motor >> Installation

Module-Power-Blower Motor: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Module-Blower Motor-R and I
GC0028312Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the blower motor power module (2) into the HVAC housing (4).
  2. Install the two screws (3) that secure the blower motor power module to the HVAC housing. Tighten the screws to 2 N.m (17 in. lbs.).
  3. Connect the two wire harness connectors (1) to the blower motor power module.
  4. Install the glove box into the instrument panel (Refer to BODY/INSTRUMENT PANEL/GLOVE BOX - INSTALLATION) .
  5. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals