LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Ignition System (Service Information)) >> Sensor-Camshaft Position >> Installation >> 3.7L V-6

3.7L V-6

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean out machined hole in cylinder head.
  2. Apply a small amount of engine oil to sensor o-ring.
  3. Install sensor into cylinder head with a slight rocking and twisting action.
    CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder head. If sensor is not flush, damage to sensor mounting tang may result.
  4. Install mounting bolt and tighten. Refer to torque SPECIFICATIONS  .
  5. Connect electrical connector to sensor.
scientia non olet · About LEMON Manuals