LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 557 (Vehicle Theft Security System - Electrical Diagnostics) >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B1A26-Maximum Number Of Keys Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  MAXIMUM AMOUNT OF KEYS PROGRAMMED INTO SKREEM 
    NOTE: The below procedure has you clearing all the key information within the SKREEM. It is important to obtain all the customer's ignition key(s) so they may be reprogrammed into the module.

    Turn the ignition on.

    Using a scan tool, clear all the key information in the SKREEM.

    Program the all the customer key(s) into the SKREEM (up to eight only)

    Was the "Maximum Number of Keys Programmed" display again? 

    Yes 

    1. Replace and program the SKREEM in accordance with the Service Information.
    2. Perform SKREEM VERIFICATION . . (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 

    No 

    1. Programming of the key(s) were successful. Test complete.
    2. Perform SKREEM VERIFICATION . . (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 
scientia non olet · About LEMON Manuals