LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 557 (Vehicle Theft Security System - Electrical Diagnostics) >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B1A24-Key Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  KEY NOT PROGRAMMED 

    Turn the ignition on.

    Using a scan tool, attempt to program the key(s) into the SKREEM.

    Was the programming of the key(s) successful? 

    Yes 

    1. Programming of the key(s) were successful. Test complete.
    2. Perform SKREEM VERIFICATION . . (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 

    No 

    1. Replace the ignition key and attempt to program it into the SKREEM. If the DTC resets, replace and program the SKREEM in accordance with the Service Information.
    2. Perform SKREEM VERIFICATION . . (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 
scientia non olet · About LEMON Manuals