LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 550 (DTCS P0463 To P0573) >> Diagnosis And Testing >> P0480-Cooling Fan 1 Control Circuit >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  LOW SPEED RADIATOR FAN RELAY OPERATION 

    Ignition on, engine not running.

    With a scan tool, actuate the Low Speed Radiator Fan Relay.

    Is the Cooling Fan Relay operating? 

    Yes 

    1. Refer to INTERMITTENT CONDITION .
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. Go To step  2).
  2. 2)  (A16) FUSED B+ CIRCUITS 

    Turn the ignition off.

    Remove the Low Speed Radiator Fan Relay.

    Using a 12-volt test light connected to ground, probe the (A16) Fused B+ circuits.

    Does the test light illuminate brightly? 

    Yes 

    1. Go To step  3).

    No 

    1. Repair the open or short to ground in the (A16) Fused B+ circuits. Inspect the related fuse and repair as necessary.
    2. Perform POWERTRAIN VERIFICATION TEST .
  3. 3)  LOW SPEED RADIATOR FAN RELAY RESISTANCE 

    Measure the resistance of the Low Speed Radiator Fan Relay Coil.

    Is the resistance between 60 to 80 ohms? 

    Yes 

    1. Go To step  4).

    No 

    1. Replace the Low Speed Radiator Fan Relay.
    2. Perform POWERTRAIN VERIFICATION TEST .
  4. 4)  (N201) COOLING FAN NO.1 CONTROL CIRCUIT OPEN 

    Disconnect the C3 FCM harness connector.

    Measure the resistance of the (N201) Cooling Fan No.1 Relay Control circuit from the Relay to the C3 FCM harness connector.

    Is the resistance below 5.0 ohms? 

    Yes 

    1. Go To step  5).

    No 

    1. Repair the open in the (N201) Cooing Fan No.1 Relay Control circuit.
    2. Perform POWERTRAIN VERIFICATION TEST .
  5. 5)  (N201) COOLING FAN NO.1 CONTROL CIRCUIT SHORTED TO GROUND 

    Measure the resistance between ground and the (N201) Cooling Fan No.1 Relay Control circuit at the Relay connection.

    Is the resistance below 100 ohms? 

    Yes 

    1. Repair the short to ground in the (N201) Cooling Fan No.1 Relay Control circuit.
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. Go To step  6).
  6. 6)  FRONT CONTROL MODULE 
    NOTE: Before continuing, check the FCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

    Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.

    Were there any problems found? 

    Yes 

    1. Repair as necessary.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Replace Front Control Module per Service Information.
    2. Perform BODY VERIFICATION TEST - VER 1 .
scientia non olet · About LEMON Manuals