LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (5.7L Engine (Service Information)) >> Manifold - Intake >> Removal

Manifold - Intake: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 5.7L WK Engine Cover
GC0027263Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove engine cover (1).
  2. Bleed fuel system (Refer to FUEL SYSTEM/FUEL DELIVERY - STANDARD PROCEDURE) .
  3. Disconnect negative cable from battery.
  4. Remove air inlet hose.
  5. Remove ignition wires from on top of intake manifold.
  6. Disconnect electrical connectors for the following components:
    • Manifold Absolute Pressure (MAP) Sensor
    • Fuel Injectors
    • ETC ( Electric Throttle Control )
  7. Remove wire harness from intake manifold.
  8. Disconnect brake booster hose, purge hose, and MUA hose ( Make Up Air Hose ).
  9. Remove EGR tube from intake manifold.
  10. Remove intake manifold retaining fasteners in a crisscross pattern starting from the outside bolts and ending at the middle bolts.
  11. Remove intake manifold as an assembly.
scientia non olet · About LEMON Manuals