Installation
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position intake manifold.
- Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 12 N.m (105 in. lbs.).
- Install EGR tube.
- Install wire harness on intake manifold.
- Connect electrical connectors for the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Fuel Injectors
- ETC ( Electronic Throttle Control )
- Install ignition wires.
- Connect Brake booster hose, purge hose, and MUA hose ( Make Up Air hose ).
- Install air inlet hose.
- Connect negative cable to battery.
- Install engine cover (1).