LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (5.7L Engine (Service Information)) >> Manifold - Exhaust >> Installation >> Exhaust Manifold

Exhaust Manifold

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Manifold Torque - Left
GC0004014Courtesy of DAIMLERCHRYSLER CORP.
Fig 2: Exhaust Manifold Torque - Right
GC0004013Courtesy of DAIMLERCHRYSLER CORP.
  1. Install manifold gasket and manifold.
  2. Install manifold bolts and tighten to 25 N.m (18 ft. lbs.).
  3. Install heat shield and tighten nuts to 8 N.m (70 in. lbs.).
  4. Install engine mounts. (Refer to ENGINE/ENGINE MOUNTING/FRONT MOUNT - INSTALLATION) .
  5. Lower engine.
    CAUTION: Do not damage engine harness while lowering the engine.
  6. Install and tighten right and left side engine mount to frame fasteners (4). (Refer to ENGINE/ENGINE MOUNTING/FRONT MOUNT - INSTALLATION) .
  7. Install exhaust flange to pipe bolts.
  8. Lower vehicle.
  9. Connect negative battery cable.
scientia non olet · About LEMON Manuals