LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Seal - Crankshaft Oil - Front >> Removal

Seal - Crankshaft Oil - Front: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Damper Removal
GC0003821Courtesy of DAIMLERCHRYSLER CORP.
1 - SPECIAL TOOL 8513 INSERT
2 - SPECIAL TOOL 1026
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  3. Remove A/C compressor mounting fasteners and set aside.
  4. Drain cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  5. Remove upper radiator hose.
  6. Disconnect electrical connector for fan mounted inside radiator shroud.
  7. Remove radiator shroud attaching fasteners.
    NOTE: Transmission cooler line snaps into shroud lower right hand corner.
  8. Remove radiator cooling fan and shroud (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
  9. Remove crankshaft damper bolt.
  10. Remove damper using Special Tools 8513 Insert and 1026 Three Jaw Puller (2).
    Fig 2: Crankshaft Front Seal Removal
    GC0003822Courtesy of DAIMLERCHRYSLER CORP.
    1 - SPECIAL TOOL 8511
  11. Using Special Tool 8511 (1), remove crankshaft front seal.
scientia non olet · About LEMON Manuals