LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Manifold - Exhaust Left >> Removal

Manifold - Exhaust Left: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative cable for battery.
  2. Hoist vehicle.
  3. Disconnect exhaust pipe at manifold.
  4. Lower vehicle.
  5. Remove air cleaner housing and tube.
  6. Remove the front two exhaust heat shield retaining fasteners. Raise vehicle and remove the fasteners at rear of heat shield.
  7. Remove heat shield. See Fig 1.
  8. Lower vehicle and remove the upper exhaust manifold retaining bolts. See Fig 1.
  9. Raise vehicle and remove the lower exhaust manifold retaining bolts. See Fig 1.
  10. Remove exhaust manifold and gasket. See Fig 1. Manifold is removed from below the engine compartment.
Fig 1: Exhaust Manifold-Left
GC0003933Courtesy of DAIMLERCHRYSLER CORP.
ITEM DESCRIPTION TORQUE ITEM DESCRIPTION TORQUE
1 Stud (Qty 2) 25 N.m (18 ft. lbs.) 4 Nut (Qty 2) 8 N.m (72 in. lbs.), then loosen 45 degrees
2 Bolt (Qty 4) 5 Nut (Qty 2)
3 Stud (Qty 2)
scientia non olet · About LEMON Manuals