LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Manifold - Exhaust Left >> Installation

Manifold - Exhaust Left: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install exhaust manifold and gasket from below engine compartment.
  2. Install lower exhaust manifold fasteners. See Figure. DO NOT tighten until all fasteners are in place.
  3. Lower vehicle and install upper exhaust manifold fasteners. See Figure. Tighten all manifold bolts starting at center and working outward to 25 N.m (18 ft. lbs.).
    CAUTION: Over tightening heat shield fasteners, may cause shield to distort and/or crack.
  4. Install exhaust manifold heat shield. See Figure. Tighten fasteners to 8 N.m (72 in. lbs.), then loosen 45 degrees.
  5. Install air cleaner housing and tube.
  6. Connect exhaust pipe to manifold.
  7. Connect negative cable to battery.
scientia non olet · About LEMON Manuals