LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Damper - Crankshaft >> Removal

Damper - Crankshaft: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Viscous Fan and Fan Drive - 3.7L/4.7L/5.7L
GC0003820Courtesy of DAIMLERCHRYSLER CORP.
1 - SPECIAL TOOL 6958 SPANNER WRENCH WITH ADAPTER PINS 8346
2 - FAN
  1. Disconnect negative cable from battery.
  2. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  3. Drain cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  4. Remove radiator upper hose.
  5. Remove upper fan shroud.
  6. Using Special Tools 6958 Spanner with Adapter Pins 8346 (1), loosen fan and viscous assembly from water pump.
  7. Remove fan and viscous assembly.
  8. Disconnect electrical connector for fan mounted inside radiator shroud.
    Fig 2: Crankshaft Damper Removal
    GC0003821Courtesy of DAIMLERCHRYSLER CORP.
    1 - SPECIAL TOOL 8513 INSERT
    2 - SPECIAL TOOL 1026
    NOTE: Transmission cooler line snaps into shroud lower right hand corner.
  9. Remove crankshaft damper bolt.
  10. Remove damper using Special Tools 8513 Insert and 1026 Three Jaw Puller (2).
scientia non olet · About LEMON Manuals