LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Cover - Cylinder Head - Right >> Removal >> Removal - Right Side

Removal - Right Side

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect battery negative cable.
  2. Disconnect battery positive cable.
  3. Remove the battery tray.
  4. Drain cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  5. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  6. Remove air conditioning compressor retaining bolts and move compressor to the left.
  7. Remove heater hoses.
  8. Disconnect injector and ignition coil connectors.
  9. Disconnect and remove positive crankcase ventilation (PCV) hose.
  10. Remove oil fill tube.
  11. Un-clip injector and ignition coil harness and move away from cylinder head cover.
  12. Remove right rear breather tube and filter assembly.
  13. Remove cylinder head cover retaining bolts.
  14. Remove cylinder head cover.
NOTE: The gasket may be used again, provided no cuts, tears, or deformation has occurred.
scientia non olet · About LEMON Manuals