LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (4.7L Engine (Service Information)) >> Cover - Cylinder Head - Right >> Installation >> Installation - Right Side

Installation - Right Side

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover-Right
GC0003900Courtesy of DAIMLERCHRYSLER CORP.
ITEM  DESCRIPTION  TORQUE 
1 Cover Fasteners 12 N.m (105 in. lbs.)
CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gasket as necessary.
  2. Install cylinder head cover and hand start all fasteners (1). Verify that all double ended studs are in the correct location shown in.
  3. Tighten cylinder head cover bolts and double ended studs to 12 N.m (105 in. lbs).
  4. Install right rear breather tube and filter assembly.
  5. Connect injector, ignition coil electrical connectors and harness retaining clips.
  6. Install the oil fill tube.
  7. Install PCV hose.
  8. Install heater hoses.
  9. Install air conditioning compressor retaining bolts.
  10. Install accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
  11. Fill Cooling system (Refer to COOLING - STANDARD PROCEDURE) .
  12. Install air cleaner assembly, resonator assembly and air inlet hose.
  13. Connect battery negative cable.
scientia non olet · About LEMON Manuals