Pan-Engine Oil: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold Tightening Sequence

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect negative battery cable.
Remove the radiator fan (Refer to COOLING/ENGINE/RADIATOR FAN - REMOVAL) .
Remove the intake manifold (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - REMOVAL) .

Fig 2: Installing Engine Support Tool
Courtesy of DAIMLERCHRYSLER CORP.
Install Special Tool #8534 Do not raise engine at this time.

Fig 3: Structural Cover
Courtesy of DAIMLERCHRYSLER CORP.
Remove the structural cover (Refer to ENGINE/ENGINE BLOCK/STRUCTURAL COVER - REMOVAL) using sequence shown in Fig 3.

Fig 4: Engine Mount Bolt
Courtesy of DAIMLERCHRYSLER CORP.
Remove both left and right side engine mount through bolts (3).

Fig 5: Engine Support Tool
Courtesy of DAIMLERCHRYSLER CORP.
Raise engine using special tool # 8534 (1), to provide clearance to remove oil pan.
Drain engine oil and remove oil filter.

Fig 6: Oil Pan Mounting Bolt Sequence
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: Do not pry on oil pan or oil pan gasket. Gasket is mounted to engine and does not come out with oil pan.
Remove the oil pan mounting bolts and oil pan.
Unbolt oil pump pickup tube and remove tube and oil pan gasket from engine.