Cover(S)-Cylinder Head: Removal
WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative cable from battery.
- Remove the resonator assemble and air inlet hose.
- Disconnect injector connectors and un-clip the injector harness.
- Route injector harness in front of cylinder head cover (2).
- Disconnect the left side breather tube and remove the breather tube.
- Remove the cylinder head cover mounting bolts (1).
- Remove cylinder head cover and gasket.
NOTE:
The gasket may be used again, providing no cuts, tears, or deformation has occurred.