LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 542 (Anti-Lock Brake System & Brake Controller - Electrical Diagnostics) >> DTC Troubleshooting >> Antilock Brake System & Electronic Stability Program >> C1243-G Sensor Not Initialized >> Monitor Conditions

Monitor Conditions

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. When Monitored: 

    Continuously after power-on reset until vehicle speed exceeds 12.4mph/20 kph for the first time, but not if the sensor voltage is out of range,

    Or, during diagnostic mode.

    Or, if the monitoring was inhaibited by a corresponding diagnostics command.

    Or, if the vehicle speed has exceeded 12.4 mph/20 kph during the actual ignition cycle.

    Or, if at least one overspinning wheel is detected.

    Or, if one of the control functions is active.

scientia non olet · About LEMON Manuals