Diagnostic Test

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The conditions that set the DTC are not present at this time. The following list may help in identifying the intermittent condition.

WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts, or fan. Do not wear loose clothing. Failure to follow these instructions can result in personal injury or death.

1. Refer to any Technical Service Bulletins (TSBs) that may apply.

2. Review the scan tool information. If possible, try to duplicate the conditions under which the DTC set.

3. Turn the ignition off.

4. Visually inspect the related wire harness. Disconnect all the related harness connectors. Look for any chafed, pierced, pinched, partially broken wires and broken, bent, pushed out, or corroded terminals.

5.Perform a voltage drop test on the related circuits between the suspected faulty component and the Memory Seat Module.

6. Inspect and clean all grounds that are related to the most current DTC.

7. If numerous trouble codes were set, use a wiring schematic and look for any common ground or supply circuits

8. Monitor with the scan tool and wiggle the related wire harness to try to interrupt the actuation.

9. Use the scan tool to perform a System Test if one applies to failing component.

10. A co-pilot, data recorder, and/or lab scope should be used to help diagnose intermittent conditions.

Were any problems found during the above inspections?

Yes

Perform the necessary repairs.
Perform APS VERIFICATION TEST - VER 1 .

Test Complete.