LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Differential & Driveline (Service Information)) >> Rear Axle - C213RE >> Axle Shaft Seals >> Installation

Axle Shaft Seals: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Axle Shaft
GC0028601Courtesy of DAIMLERCHRYSLER CORP.
  1. Install axle shaft (1) into axle tube and backing plate with new o-ring on axle.
    Fig 2: Axle Bearing O-Ring
    GC0028602Courtesy of DAIMLERCHRYSLER CORP.
  2. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
  3. Install new O-ring (2) on axle bearing (1).
    Fig 3: Axle Flange Bolts
    GC0028603Courtesy of DAIMLERCHRYSLER CORP.
  4. Push axle into axle tube.
  5. Install axle (2) flange nuts (1) and tighten to 119 N.m (88 ft. lbs.).
    Fig 4: Speed Sensor
    GC0028604Courtesy of DAIMLERCHRYSLER CORP.
  6. Install speed sensors (2) in axle tube (1) flange.
  7. Install calipers and rotors.
scientia non olet · About LEMON Manuals