LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2005 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Differential & Driveline (Service Information)) >> Front Axle - C200FE >> Bearings-Axle >> Removal

Front Axle - C200FE: Bearings-Axle: Removal

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Axle Seal Remover
GC0028434Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove axle shaft.
  2. Remove axle shaft tube (1) seal with Remover 7794-A (2) and slid hammer.
    Fig 2: Axle Bearing Remover
    GC0028436Courtesy of DAIMLERCHRYSLER CORP.
  3. Install axle bearing remover C-4660-A (1) into the axle bearing (2) in the axle tube (3) and tighten remover nut (4).
    Fig 3: Axle Bearing Receiver
    GC0028433Courtesy of DAIMLERCHRYSLER CORP.
  4. Install bearing Receiver 9537 (1) and nut (2) on remover and tube (3). Tighten nut (2) and draw bearing into receiver (1).
scientia non olet · About LEMON Manuals